try to change research point but failed

[willkzhang]

My mod does not work. The following steps are what I have tried. Can someone point out where I did wrong please?

1. Open the table "technologies", then change every entry of shogun single player to 100. Apply the changes.Close the table.

2. export single table. select "technologies" and check export dependency.

3. open bob, check retail->data->mod.pack
when the progress bar goes to green,exit.

4. copy modding/retail/data/mod.pack into total war SHOGUN 2/data

5. open the game and get redirected to mod launcher.choose mod.pack. launch game.

6. start a new campaign as otomo clan.but in game the required turns for arts didnt change.

This is the 1st time I use assembly kit,I followed the guide on the web and tried few times, but it still wont work. Please kindly tell me what I am missing.

Also, how do I change the range of matchlock?
in the "units" table,there doesnt seem to be a column for missile attack range.

Thanks in advance.

[Varus2319]

I haven't gotten any mods to work either, following essentially the same steps you have. The modders on these forums are 90 steps ahead of us, and all the tutorials skip the most basic stuff.

They all seem to assume we know how to do the small things, which we don't. I think there are files we need to extract first, or who knows what else, but there are probably 3 or 4 things that nobody has told us about.

I've been trying to figure out how to use Pack File Manager on for about 12 hours now, and I still can't even figure out how to save my work. There's just no information out there on the little things.

[Ygge]

Instead of exporting tables with TWeak I export with BOB and my mod works just fine, heres what I do: After applying, close TWeak, open BOB. Then check the "technologies" table in the left column under "db", go to the middle column "working data" and find Technologies table there(Should be blue) and check it, then check both provider and consumer actions. Then press start and let BOB do its job. Then find you mod i the folder retail/data and copy paste to Shogun 2/data.

[Varus2319]

Instead of exporting tables with TWeak I export with BOB and my mod works just fine, heres what I do: After applying, close TWeak, open BOB. Then check the "technologies" table in the left column under "db", go to the middle column "working data" and find Technologies table there(Should be blue) and check it, then check both provider and consumer actions. Then press start and let BOB do its job. Then find you mod i the folder retail/data and copy paste to Shogun 2/data.

See I do this, and nothing ever happened unless I export first with Tweak, then open bob and do it again.