-
March 03, 2017, 12:32 PM
#1
Joints ... sword at the side
Hi again!
I've merged a pike and the case of the sword with only the top of a sword.
(The unit, when using the pike, has a sword by the side which is not used.)
The problem: the top of the sword flies arount. I think it might have to do with the joints... because I've
ajusted it right in milkshape. What should I do with the joints?
Thanks for your help.
-
March 03, 2017, 12:43 PM
#2
Re: Joints ... sword at the side
hard to tell without see model or a picture of that problem
-
March 03, 2017, 01:01 PM
#3
Re: Joints ... sword at the side
-
March 03, 2017, 01:12 PM
#4
Re: Joints ... sword at the side
PS: I know I forgott to merge the two files. But even though it doesn't work...
-
March 03, 2017, 01:46 PM
#5
Re: Joints ... sword at the side
Assign the sword top to lthigh (or holster to pelvis). Both have to be assigned to the same bone
-
March 03, 2017, 01:58 PM
#6
Re: Joints ... sword at the side
-
March 04, 2017, 02:53 AM
#7
Re: Joints ... sword at the side
Thanks a lot !!! It worked
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules